Table of Contents
Advertisement
11.18 MX826 VIDEO DISTRIBUTION MODULE
11.18.1
General
The MX826 Video Distribution Module is a two (2) channel Video Input Distribution
Module with three (3) outputs per channel.
Designed specifically to enable video distribution from the MAXPRO-Net
HD Series HMX32128 subrack, the module can be installed into any* of the 16 Video
Input slots (1 – 16), or any* of the Video Output Slots (1 - 4) on the
HMX32128 Subrack.
* Denotes – If installing MX-826 Modules into a MX-32128 Subrack they MUST NOT be
installed in between or before Input Modules (MX-832 / MX-832L) so as not to break the
video input bus in the Subrack.Whatever warning needed.
If the HMX32128 is being used solely for Video Distribution (only populated with MX-826
Modules) then a MX-128 Subrack Controller Module is not required.
No programming is required within SETMAX to enable the module, so installation and
operation is simple.
11.18.2
Operation
BNC connector number 1 (top of the module) is the first video input channel. The
following three (3) BNC connectors are the distributed video signal outputs.
BNC connector number 5 is the second video input channel. The following three (3)
BNC connectors (bottom 3 of the module) are the distributed video signal outputs.
Rev. C
CAUTION: The MX826 cannot be installed in Slot 0
(most left-hand-side slot) of the HMX32128. This slot is
reserved for the HMX128 Subrack Controller Module
only.
11-16
HMXMU001018
10/06
Advertisement
Table of Contents
