Mitsubishi Electric M700VS Series Setup Manual page 71

MITSUBISHI CNC
4 Setting the Parameters and Date/Time
(Note 1) These parameters are not set on the system setup screen. Use the parameter screen to set them.
(Note 2) Refer to the section of "Explanation of Parameters" for the details of the parameters.
You can also refer to the parameter guidance display.
(Note 3) Parameters "#3001 slimt1 (Limit rotation speed (Gear: 00))" to "#3004 slimt4 (Limit rotation speed (Gear:
11))" are set with the spindle rotation speed which can be attained at the spindle motor's maximum
rotation speed. This value is obtained by multiplying the gear ratio on the value of "#13026 SP026 TSP
(Maximum motor speed)". Parameters "#3005 smax1 (Maximum rotation speed (Gear: 00))" to "#3008
smax4 (Maximum rotation speed (Gear: 11))" are set when the rotation speed is to be limited according
to the machine specifications, such as the spindle gear specifications. Up to four value can be set for
gear changeover.
54
SP026
0
smax1 slimt1 smax2
Spindle rotation speed (r/min)
slimt2 smax(n) slimt(n)