Mitsubishi Electric M700VS Series Setup Manual page 330

【#2149】 Blf_E2 Reference amount of position-dependent increasing-type backlash
compensation 2
Set the compensation amount for specifying the compensation change rate in position-dependent
increasing-type backlash compensation.
Blf_E1
Blf_E2
When "#2146 Blf_E1" is set to "0", the position-dependent increasing-type backlash compensation
function will be disabled.
---Setting range---
0 to 9999999 (Machine error compensation unit)
【#2150】 Rot_len Farthest distance from rotary axis center
Set the farthest distance of the rotating part from the rotation center for executing the 3D machine
interference check.
When "0" is set, this distance will conform to the rotary axis' specification speed.
---Setting range---
0.000 to 99999.999(mm)
【#2151】 rated_spd Rated speed
Set the maximum speed which can be driven with the motor's maximum torque.
(Note 1) This parameter's setting value must be smaller than "#2001 rapid Rapid traverse". If bigger,
(Note 2) If rapid traverse constant inclination multi-step acceleration/deceleration is valid, and also if
Torque
---Setting range---
0 to 1000000(mm/min)
Blf_L2 Blf_L1
constant inclination acceleration/deceleration will be applied.
this parameter is set to "0", constant inclination acceleration/deceleration will be applied.
Speed
rapid
rated_spd
Speed
rated_spd
rapid
Appendix 1.3 Axis Specifications Parameters
G0t_rated
Time
M700VS Series Setup Manual
313