Mitsubishi Electric M700VS Series Setup Manual page 488

【#10969(PR)】 Condition kind 10
Set the condition (alarm or PLC signal) for the automatic notification of alarms.
Set the alarm type for alarm, device (register) name for PLC signal.
<Alarm>
Operation alarm (Mxx)
Stop code (Txx)
Servo alarm (Sxx)
Spindle servo alarm (Sxx)
System alarm (Zxx)
Absolute position detection alarm (Zxx)
Emergency stop (EMG)
Auxiliary axis servo alarm (Sxx)
Auxiliary axis absolute position detection alarm (Zxx)
Auxiliary axis OP error (Mxx)
Auxiliary axis MCP alarm (Yxx)
Computer link error (Lxx)
Operation error (Exx)
User PLC alarm (PLxx)
<Device (resister)>
1-bit data ... X,Y,U,W
16-bit data ... R
(Note) Set "0" to cancel (set blank for) any setting of #10951 to #10970, "Condition kind" 1 to 10 and
---Setting range---
Within 5 characters
【#10970(PR)】 Condition num 10
Set the condition (alarm or PLC signal) for the automatic notification of alarms.
Set the alarm No. for alarm, status value for PLC signal.
(Note) Set "0" to cancel (set blank for) any setting of #10951 to #10970, "Condition kind" 1 to 10 and
---Setting range---
Within 4 characters
【#10971】 Complete condition
Set the of the PLC signal which will be the condition for completing the machining when "#10814
OP-notice condition" is set to "1".
<Device (Register)>
1 bit data : X,Y,M,F,L,SM,T,C
16 bit data : D,R
* T: Timer coil only / C: Counter coil only
---Setting range---
Within 6 alphanumeric characters
【#10972】 Complete CND num
Set the state values of PLC signal device which will be the condition for completing the machining
when "#10814 OP-notice condition" is set to "1".
Use the device status set to "#10971 Complete condition". Set the conditions of 16 bit data in HEX
format.
---Setting range---
Within 4 alphanumeric characters
Appendix 1.15 Anshin-net Parameters 2/ MTB-net Parameters 2
"Condition num" 1 to 10.Input "00" to set "Condition num" to "0".When either of "Condition kind"
or "Condition num" is canceled, the condition will not be available for the automatic notification
of alarms.
"Condition num" 1 to 10.Input "00" to set "Condition num" to "0".When either of "Condition kind"
or "Condition num" is canceled, the condition will not be available for the automatic notification
of alarms.
M700VS Series Setup Manual
471