Mitsubishi Electric M700VS Series Setup Manual page 236

【#19405】 Rotary ax drawing
Specify this parameter to draw a path of C axis (rotary axis) according to its rotation in the graphic
trace and 2D graphic trace.
When "#1013 axname" is set to "C", the axis is handled as a rotary axis.
By setting this parameter to "C", a rotation path around the Z axis on actual workpiece can be
expressed.
When the Graphic check rotary axis drawing option or Graphic trace rotary axis drawing option is
disabled, this parameter is ignored.
C：Enable this function
0：Disable this function
（Setting is cleared when "0" is set）
【#19425】 ManualB Std R1
Set a radius used as standard for the rotary axis speed.
When the setting value of #19425 is larger than that of "#19427 ManualB Std R2", #19425 setting
will be used as surface speed control standard radius 2: #19427 setting will be used as surface
speed control standard radius 1.
---Setting range---
0 to 99999.999 (mm)
【#19426】 ManualB Std F1
This sets the rotary axis speed for surface speed control standard radius 1 (ManualB Std R1).
When the setting value of #19426 is larger than that of "#19428 ManualB Std F2", #19426 setting will
be used as surface speed control standard speed 2: #19427 setting will be used as surface speed
control standard speed 1.
---Setting range---
1 to 1000000 (°/min)
【#19427】 ManualB Std R2
Set a radius used as standard for the rotary axis speed.
When the same value is set as "#19425 ManualB Std R1", the surface speed control standard speed
1 (ManualB Std F1) will be selected as the rotary axis speed if the radius is less than that value. The
surface speed control standard speed 2 (ManualB Std F2) is selected if larger than the set value.
---Setting range---
0 to 99999.999 (mm)
【#19428】 ManualB Std F2
Set the rotary axis speed for surface speed control standard radius 2 (ManualB Std R2).
---Setting range---
1 to 1000000 (°/min)
M700VS Series Setup Manual
Appendix 1.1 User Parameters
219