Mitsubishi Electric M700VS Series Setup Manual page 373

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#3031(PR)】 smcp_no Drive unit I/F channel No. (spindle)
Set the interface channel No. of CNC control unit to which the spindle is connected and the axis No.
within each channel.
Set this parameter in 4-digit (hexadecimal) format.
HEX-
HEX-4 : Drive unit interface channel No.
HEX-3 : Not used. Set to "0".
HEX-2, 1 : Axis No.
For a spindle to be connected to CNC via analog interface, set to "0000".
---Setting range---
1001 to 1010, 2001 to 2010
- For MDS-DM-SPV2/SPV3 Series
These drive units have no rotary switches for axis No. selection.
The spindle axis No. is fixed to 1st axis, so set "01" as the number of axes. (last 2 digits).
【#3032】
Not used. Set to "0".
【#3035(PR)】 spunit Output unit
Select the data unit for communication with the spindle drive unit.
This selection is applied to the data communicated between the NC and spindle drive unit as well as
the spindle movement data. Note, however, that this parameter is enabled only for the MDS-D
Series spindle drive unit.
Spindle/C axis depends on this parameter setting and the C axis output unit (servo) is ignored.
When MDS-D Series is used, follow the setting of "#1003 ctrl_unit".
B: 1μm
C: 0.1μm
D: 10nm
E: 1nm
【#3037】 taps21 Synchronous tap switching spindle speed 2 (Gear: 00)
Set the spindle speed at which the 2nd step acceleration/deceleration time constant is to be
switched with gear 00.
---Setting range---
0 to 99999 (r/min)
【#3038】 taps22 Synchronous tap switching spindle speed 2 (Gear: 01)
Set the spindle speed at which the 2nd step acceleration/deceleration time constant is to be
switched with gear 01.
---Setting range---
0 to 99999 (r/min)
356
4 3 2 1
0
Axis No.
Interface channel
No.
Axis No.=
Channel No.=1
Channel No.=2
CNC
control
unit
Axis No.= 1
Channel No.=m
Rotary switch settings
3
1 2
Spindle
drive
unit
2 n