Mitsubishi Electric M700VS Series Setup Manual page 275

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1265(PR)】 ext01
bit0: Command format 1
Select the command format for the fixed cycle for compound lathe.
0: Conventional format
1: MITSUBISHI CNC special format (1 block command method)
bit1: Command format 2
Select the command format for the lathe fixed cycle.
0: Conventional format
1: MITSUBISHI CNC special format
bit2: Command format 3
Select the command format for the hole drilling fixed cycle.
0: Conventional format
1: MITSUBISHI CNC special format
【#1266(PR)】 ext02
Not used. Set to "0".
【#1267(PR)】 ext03
bit0: G code type
Select the high-speed high-accuracy G code type.
0: Conventional format (G61.1)
1: MITSUBISHI special format (G08P1)
【#1268(PR)】 ext04
bit2 : Enable synchronous tapping per minute
Select whether to enable feed per minute with the F command of synchronous tapping cycle.
0: Disable (Command in pitch regardless of "G group 5" modal)
1: Enable (Follow "G group 5" modal)
【#1269(PR)】 ext05
Not used. Set to "0".
【#1270(PR)】 ext06
bit3 : Finished shape judgement disable
Select to enable/disable the judgement of shape when the finished shape's Z axis (or X axis at G72
command) does not move monotonously. Program error (a shape change at pocket machining) can
be avoided when selected to disable.
0：Enable
1：Disable
bit5: Coordinate rotation angle without command (for L system only)
Select the operation when there is no rotation angle command R for the coordinate rotation.
0: Use the previously commanded value (modal value). If the command is the first issued
1: Use the set value in "#8081 Gcode Rotat".
bit6: Switch continuous thread cutting Z phase wait operation
Select when to start the 2nd block thread cutting when there is a command with no movement (MST
command, etc.) between the thread cutting blocks.
0: Wait for the spindle's single rotation synchronization signal before starting the movement.
1: Start movement without waiting for the spindle's single rotation synchronization signal.
bit7: Handle C axis coordinate during cylindrical interpolation
Specify whether to keep the rotary axis coordinate as before the cylindrical interpolation start
command is issued during the cylindrical interpolation.
0: Not keep
1: Keep
258
command, the rotation angle will be 0°.