Mitsubishi Electric M700VS Series Setup Manual page 57

MITSUBISHI CNC
3 Setting Up with M70/M700 SETUP INSTALLER
(2) Select the language to install with the menu key.
The language selected is shown in the "Now Selected Language" field.
(Note 1) To change the selected language, press [Clear] before selecting again.
(Note 2) The 2nd language can be selected when the expansion FROM is provided. (Cursor moves to the "2nd"
field after the 1st language has been selected.)
(3) Select [Install].
(4) A confirmation message appears. Select [Yes] to start the installation.
(5) A message appears when the installation has been completed.
(Note 1) Selecting [No] displays the language selection menus.
(Note 2) The language data installation takes about 105 seconds. Do not turn the power OFF during the
installation.
(6) To close M70/M700 SETUP INSTALLER, turn the power OFF and ON.
To return to the Mode Select screen, press the cancel key
40
(<< Cancel).