Mitsubishi Electric M700VS Series Setup Manual page 296

【#1569】 SfiltG0 G00 soft acceleration/deceleration filter
Set the filter time constant for smoothly changing the acceleration rate for the rapid traverse
acceleration/deceleration in pre-interpolation acceleration/deceleration.
---Setting range---
0 to 200 (ms)
【#1570】 Sfilt2 Soft acceleration/deceleration filter 2
Set the filter time constant for smoothly changing the acceleration rate in pre-interpolation
acceleration/deceleration.
This will be disabled when "0" or "1" is set.
---Setting range---
0 to 50 (ms)
Notch frequency Hz
Displays the notch frequency(Hz) for the S-pattern filter set in "#1570 Sfilt2 (Soft acceleration/
deceleration filter 2)".
【#1571】 SSSdis SSS control adjustment coefficient fixed value selection
Fix the shape recognition range for SSS control.
【#1572】 Cirorp Arc command overlap
This eliminates speed fluctuations at the joint of the arc and straight line and arc and arc.
Set as a bit unit.
0: Do not overlap the arc command blocks
1: Overlap the arc command blocks
bit0 : Arc command during high-speed high-accuracy control II
bit1 : Arc command during high-speed machining mode II
bit2 : Arc command during high-accuracy control (G61.1)
bit3 : Arc command during cutting mode (G64)
The line command block and arc command block won't be overlapped during G61.2 modal
regardless of this setting.
(Note) This parameter is invalid during SSS control.
【#1573】 Ret1 Return type 1
Select the axis to be moved later after tool return.
This is referred to with the movement path (transit point #1 -> interrupt point).
Up to eight axes can be specified by expressing one axis with one bit.
bit0 : Transit point #1 1st axis
bit1 : Transit point #1 2nd axis
bit2 : Transit point #1 3rd axis
bit3 : Transit point #1 4th axis
bit4 : Transit point #1 5th axis
bit5 : Transit point #1 6th axis
bit6 : Transit point #1 7th axis
bit7 : Transit point #1 8th axis
---Setting range---
00000000 to 11111111 (Binary)
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
279