Mitsubishi Electric M700VS Series Setup Manual page 423

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#13238】 SP238 SSCFEED Safety observation Safety speed
Set the safety speed at the spindle end for the safety observation function.
When not using, set to "0".
---Setting range---
0 to 18000 (゜/min)
However, when SP229/bitD is set to "1", the setting range is from -32768 to 32767 (100゜/min).
【#13239】 SP239 SSCRPM Safety observation Safety motor speed
Set the motor's safety speed for the safety observation function.
When not using, set to "0".
---Setting range---
0 to 32767 (r/min)
【#13240(PR)】 SP240
Not used. Set to "0".
【#13241(PR)】 SP241
This is automatically set by the NC system.
【#13242(PR)】 SP242
This is automatically set by the NC system.
【#13243(PR)】 SP243
This is automatically set by the NC system.
【#13244(PR)】 SP244
This is automatically set by the NC system.
【#13245(PR)】 SP245
This is automatically set by the NC system.
【#13246(PR)】 SP246
This is automatically set by the NC system.
【#13247(PR)】 SP247
This is automatically set by the NC system.
【#13248(PR)】 SP248
This is automatically set by the NC system.
【#13249(PR)】 SP249
This is automatically set by the NC system.
【#13250(PR)】 SP250
This is automatically set by the NC system.
【#13251(PR)】 SP251
This is automatically set by the NC system.
【#13252(PR)】 SP252
This is automatically set by the NC system.
【#13253(PR)】 SP253
This is automatically set by the NC system.
406