Flow Of Initial Setup - Mitsubishi Electric M700VS Series Setup Manual

MITSUBISHI CNC
1 Setup Outline

1.3 Flow of Initial Setup

The following flow chart shows the procedures of the initial setup.
(Note) When setting up with backup files, refer to the section of "Data Backup and Restoration".
WARNING Do not cancel the emergency stop before confirming the basic operation.
Start
Confirming the connection between
control unit and peripheral devices
Connecting and setting the hardware
Setting Up with
M70/M700 SETUP INSTALLER
Setting Parameters and Date/Time
PLC Program Writing
Confirming the Basic Operation
Setting the Position Detection System
Setting the stored stroke limit
Confirming the Spindle Operation
Inputting the machining program
For other settings, refer to the following sections:
- Setting the Deceleration Check
- Data Backup and Restoration
4
Points
Is the power supply within a specified range?
Is the power supply polarity correct?
Is the connection of the motor power cable and the detector cable correct?
Is the grounding correct?
Refer to section 2
Carry out the connecting and setting of drive units, batteries and remote I/O units.
Initialize the NC Internal data (SRAM).
Refer to section 3
Carry out this procedure when installing language data other than Japanese and
English, as well as custom screens.
(Note) If you do not need the installation, go to the next procedure.
Refer to section 4
Set the parameters on the system setup screen and the parameter screen.
Set the date and time on the integrated time screen.
Refer to section 5
Write the created PLC program to NC's ROM using GX Developer.
Refer to section 6
Confirm the input/output of signals, the alarm display and the manual operation.
Refer to section 7
Carry out the setting for establishing the reference position (zero point).
Refer to section 8
Set the tool entry prohibited range.
Refer to section 9
Confirm that the spindle operates properly in manual/MDI operation.
Confirm the spindle rotation speed as well.
Refer to Instruction Manual
End