Display Unit - Mitsubishi Electric M700VS Series Setup Manual

12.3 Display Unit

[Replacement procedures]
Always replace the display unit with the control unit (machine) power turned OFF.
(1) Check that the machine power is turned OFF. (If the power is not OFF, turn it OFF.)
(2) Open the electric cabinet door.
(3) Disconnect all the cables connected to the display unit.
(4) Remove the screws fixing the display unit (at 4 places) and take the display unit off.
(5) Install a new display unit with fixing screws.
(6) Connect all the cables back to the display unit. (Always connect the cables to the designated connectors.)
(7) Confirm that all the cables are correctly connected and close the electric cabinet door.
1. Incorrect connections could cause devices to damage. Connect the cables to designated
connectors.
CAUTION
2. Do not replace the display unit while the power is ON.
3. Do not connect or disconnect the cables between units while the power is ON.
M700VS Series Setup Manual
Fixing screws (4)
12.3 Display Unit
141