Mitsubishi Electric M700VS Series Setup Manual page 269

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1231】 set03
bit0: Graphic check compatibility parameter
Select whether to return the data to the pre-starting data after having checked a machining program
that rewrites the common variables, workpiece offsets and tool offsets.
0: Return the data.
1: Not return the data.
bit1: Switch graphic trace coordinates
Select whether to use machine coordinate value or tool position coordinate value (position being
machined, obtained by subtracting the tool compensation amount from machine coordinate values)
for drawing with trace display.
0: Machine coordinate value (conventional method)
1: Tool position coordinate value
bit2: Switch graphic check trace
Select the coordinates to draw at program check: both machine coordinate value (tool center path)
and tool position coordinate value (program path) simultaneously, or only the coordinates selected
with "#1231 set03/bit1 (Switch graphic trace coordinates)".
0: Both machine coordinates and tool position coordinates (conventional method)
1: Only coordinates designated with switch graphic coordinates
bit4: Switch zero point mark display position
Select the position for displaying the basic point mark in the graphic trace and 2D check.
0: Machine coordinate basic point (same as conventional method)
1: Workpiece coordinate basic point
bit5: Switch graphic check counter display
Select the type of counter displayed on the Graphic Check screen with the combination of "#1231
set03/bit1".
If the drawing coordinate system is other than "all workpiece coordinates", the counter displayed is
workpiece coordinate position counter or tool position (workpiece coordinate) regardless of this
setting.
0: (When "#1231 set03/bit1" is set to "0") Machine position counter
1: (When "#1231 set03/bit1" is set to "0") Workpiece coordinate counter
【#1232】 set04
Not used. Set to "0".
【#1233】 set05
bit1 : Spindle clamp selection
Select whether to enable/disable the spindle override for the spindle speed clamp command (G92
S?).
0：Disable
1：Enable
【#1234】 set06
bit3: Interlock when tap retract enabled
Select whether to enable automatic/manual interlock for the part system with "Tap retract enable"
signal ON.
0: Interlock all the axes
1: Disable the interlock
252
(When "#1231 set03/bit1" is set to "1") Tool position (workpiece coordinate) counter
(When "#1231 set03/bit1" is set to "1") Tool position (workpiece coordinate) counter