Appendix 1.18 Unit; Appendix 1.19 Inputting The Machine Parameters - Mitsubishi Electric M700VS Series Setup Manual

MITSUBISHI CNC
Appendix 1 Explanation of Parameters

Appendix 1.18 Unit

(1) Input setting unit and number of decimal digits
The number of digits in the decimal section of the parameters related to length is determined by the input setting
unit.
The input setting unit is set with parameter "#1003 iunit".
Input setting unit
B
C
D
E
The setting ranges indicated in this manual use the input setting unit "B".

Appendix 1.19 Inputting the Machine Parameters

A password input is required to set the machine parameters.
Inputting the machine parameter password
(1) Press the function key [MAINTE].
The menu for the maintenance related screen will appear.
(2) Press the menu [Param].
The parameter menu will appear.
(3) Press the machine parameter selection menu.
(Example) Menu [Base sys param]
A message prompting input of the password will appear.
If the password has been input once after the power was turned ON, the cursor will appear at the machine
parameter screen.
(4) Enter the password and press the [INPUT] key. (Password: MPARA)
The cursor will appear at the machine parameter screen, and the machine parameters can be set.
(Note 1) Refer to the section of "Base Specifications Parameters" and the following for the details of the machine
parameters.
(Note 2) Always turn the power OFF after setting the machine parameters.
(Note 3) To enter the character "A", press the shift key and then "A" key. Do not press both keys at the same time.
484
Number of digits
in decimal Example of setting range
section
3 0 to 999.999 (mm)
4 0 to 999.9999 (mm)
5 0 to 999.99999 (mm)
6 0 to 999.999999 (mm)