Mitsubishi Electric M700VS Series Setup Manual page 188

【#8319】 Stock Angle (R) (for L system only)
Set the angle for the right tailstock end section.
The angle will be interpreted as 90° if there is no setting (when "0" is set).
---Setting range---
0 to 180 (°)
0: 90° (default)
【#8621】 Coord rot plane (H)
Set the plane (horizontal axis) for coordinate rotation control.
Usually, set the name of the 1st axis.
When this parameter is not set, the coordinate rotation function will not work.
---Setting range---
Axis name
【#8622】 Coord rot plane (V)
Set the plane (vertical axis) for coordinate rotation control.
Usually, set the name of the 2nd axis.
When this parameter is not set, the coordinate rotation function will not work.
---Setting range---
Axis name
【#8623】 Coord rot centr (H)
Set the center coordinates (horizontal axis) for coordinate rotation control.
---Setting range---
-999999.999 to 999999.999 (mm)
【#8624】 Coord rot centr (V)
Set the center coordinates (vertical axis) for coordinate rotation control.
---Setting range---
-999999.999 to 999999.999 (mm)
【#8625】 Coord rot vctr (H)
Set the vector components (horizontal axis) for coordinate rotation control.
When this parameter is set, the coordinate rotation control angle (#8627) will be automatically
calculated.
---Setting range---
-999999.999 to 999999.999 (mm)
【#8626】 Coord rot vctr (V)
Set the vector components (vertical axis) for coordinate rotation control.
When this parameter is set, the coordinate rotation control angle (#8627) will be automatically
calculated.
---Setting range---
-999999.999 to 999999.999 (mm)
【#8627】 Coord rot angle
Set the rotation angle for coordinate rotation control.
When this parameter is set, the coordinate rotation vector (#8625, #8626) will be "0".
---Setting range---
-360.000 to 360.000 (°)
M700VS Series Setup Manual
Appendix 1.1 User Parameters
171