Mitsubishi Electric M700VS Series Setup Manual page 220

【#9524】 DEV4 EIA CODE *
Set the code in hexadecimal, which does not duplicate the existing EIA codes, for the special code
"*".
When output with EIA code, data can be output using the alternate code in which the special ISO
code, not included in EIA, is specified.
---Setting range---
0 to FF (hexadecimal)
【#9525】 DEV4 EIA CODE =
Set the code in hexadecimal, which does not duplicate the existing EIA codes, for the special code
"=".
When output with EIA code, data can be output using the alternate code in which the special ISO
code, not included in EIA, is specified.
---Setting range---
0 to FF (hexadecimal)
【#9526】 DEV4 EIA CODE :
Set the code in hexadecimal, which does not duplicate the existing EIA codes, for the special code "
: ".
When output with EIA code, data can be output using the alternate code in which the special ISO
code, not included in EIA, is specified.
---Setting range---
0 to FF (hexadecimal)
【#9527】 DEV4 EIA CODE $
Set the code in hexadecimal, which does not duplicate the existing EIA codes, for the special code
"$".
When output with EIA code, data can be output using the alternate code in which the special ISO
code, not included in EIA, is specified.
---Setting range---
0 to FF (hexadecimal)
【#9528】 DEV4 EIA CODE !
Set the code in hexadecimal, which does not duplicate the existing EIA codes, for the special code
"!".
When output with EIA code, data can be output using the alternate code in which the special ISO
code, not included in EIA, is specified.
---Setting range---
0 to FF (hexadecimal)
【#9601】 BAUD RATE
Select the rate at which data is transferred.
0: 19200 (bps)
1: 9600
2: 4800
3: 2400
4: 1200
5: 600
6: 300
7: 110
8: 38400
【#9602】 STOP BIT
Select the stop bit length used in the start-stop system.
Refer to "#9603 PARITY EFFECTIVE". At the output of data, the number of characters is always
adjusted to for the parity check.
1: 1 (bit)
2: 1.5
3: 2
M700VS Series Setup Manual
Appendix 1.1 User Parameters
203