Setting Up Cue Tones - Cisco D9824 Installation And Configuration Manual

Setting up Cue Tones

1 From the user interface of the D9824, click Audio & Video > Other Outputs,
expand Cueing and then click Cue Tone. The Cue Tone page is displayed.
2 The Sequence Number lists the tone sequences. The receiver supports up to 16
tone sequences. You can configure the state, tones, mode, and delay for each tone
sequence.
3 Set the Sequence State (Enabled or Disabled) of the current tone sequence. When
disabled, no cue tone is output.
4 In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5 Select the tone Sequence Mode.
Select * for start tone, # for the end tone, and */# for the start and end tones. The
end tone is signaled after waiting the time specified in Sequence Delay.
6 If the Sequence Mode was set to */# (Start/Stop), set the Sequence Delay, in
seconds, between the start and stop sequences. You can enter a value in the
range from 1 to 255. The default is 30.
7 Click Apply.
78-4039426-01 Rev D
Setting up Audio and Video Information
163