Setting Up The Asi Input - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up the ASI Input

1 From the user interface of the D9824, click Input > Input Setup. The Input Setup
page is displayed.
2 Click on the ASI tab.
3 Select Use ASI Input to tune to the ASI input.
Note: Setting a new input to be active will deactivate the currently active input.
4 The ASI Input Status section displays the current RF status. The following table
describes the ASI Input Status information displayed:
Parameter
Active Input
Signal Status
Input Rate (Mbps)
ASI Link
132
Description
Indicates the currently selected input source (RF1, RF2, RF3,
RF4, or ASI).
Indicates whether the input signal is locked.
Locked - Indicates the receiver is locked to a carrier

with no valid content.
Lock+Sig - Indicates the receiver is locked to a carrier

with valid content.
No Lock - Indicates the receiver is not locked to a

carrier.
Displays the bit rate of the input transport stream, in Mbps.
Indicates whether there is a transport stream link error (Error,
Ok, or N/A).
78-4039426-01 Rev D