Cisco D9824 Installation And Configuration Manual page 210

Chapter 5 Web GUI Setup and Monitoring
7 The Protocol Control section allows you to control remote access protocols to the
IRD (Telnet, SSH, DTX, HTTP, and SNMP). In the Telnet, SSH, DTX, and SNMP
drop-down list, select Enable (default) to allow Telnet, Secure Shell, DTX, and/or
SNMP connections. Otherwise, select Disable. In the HTTP drop-down list, select
Disable to disable web connections. Select Enable (default) to allow web
connections.
The following lists the associated port numbers for each protocol:
Protocol
Telnet
SSH
HTTP
DTX
SNMP
For information on accessing TCP/IP services, see Accessing TCP and UDP
Services (on page 69).
8 In the Idle Timeout (seconds) field, enter the number of seconds before the
session for all the enabled protocols will timeout due to inactivity.
9 Click Apply.
188
Port Number
TCP port #23
TCP port #22
TCP port #80
UDP port #8401
UDP port #161
78-4039426-01 Rev D