Cisco D9824 Installation And Configuration Manual page 192

Chapter 5 Web GUI Setup and Monitoring
16 To remove a PID mapping, select the entry you want to remove and click Delete.
17 In the DPM Program Entry Setup section, each PE output can be synchronized to
its input according to one of the four output modes. Select the program entry
you want to synchronize and then click Resynchronize or click Resynchronize
All to synchronize the inputs to the outputs according to the service assignments
only.
Note: The resynchronization will not synchronize the inputs if there is no valid
input on the PE or if the PE is set to channel 0.
The Confirm Resynchronization window is displayed.
18 Select whether you want to synchronize the PE output according to the services
and then the PIDs assigned to each service, services only, PIDs only, or to
synchronize using a template.
Map Mode
Resynchronize Program, PMT
PID, ES List & ES PIDs
Resynchronize ES List
Resynchronize ES PIDs
Resynchronize Template ES List
& PIDs
19 Click Yes.
20 In the DPM General Settings section, you can configure ASI DPM transport
stream settings.
21 In the Remapping Mode drop-down, select the DPM mapping mode for this
output. The following table describes each mode:
170
Description
The receiver will synchronize the PE output according to
the services and then the PIDs assigned to each service.
The receiver will synchronize the PE output according to
the available input services only, and ignore the input to
output service PID mapping.
The receiver will synchronize the PE output according to
the input PIDs only, and ignore the service assignment
categories/names.
Allows you to preset the input to output mapping of a PE
according to the preset template. This is helpful in pre-
configuring any number of PEs for future use.
78-4039426-01 Rev D