Cisco D9824 Installation And Configuration Manual page 165

8 Select the CAM slot (CI Slot) to use for decryption. If you set the CI slot to
AUTO for PE1, the software automatically assigns the slot capable of decrypting
the stream.
Note: If CI Slot is set to AUTO, Decrypt must be set to ON.
Select TOP to use the top CAM slot for decryption or select BOTTOM to use the
bottom CAM slot for decryption.
9 The Decryption Mode Determines whether to decrypt the channel or to specify
the specific components to decrypt (ON, OFF, Comp). Select ON (default) to
decrypt the entire program entry. Select Comp to decrypt specific components,
as specified in the CI Component Setup list.
Note: If the CI Slot is set to Auto for PE1, then Decrypt can only be set to ON.
10 If you selected Comp, you must configure the parameters in the CI Components
Setup section below.
11 The CI Component Setup section allows you to insert and maintain customized
records:
12 Each record customizes the PID or stream type to decrypt. The Index number is a
read only field that indicates the record number. You can maintain up to 64
records, 32 records for each CAM.
13 To insert a new record, click Add. A new row appears at the top of the table (see
below).
There are various configurations when creating a new record. The following
table summarizes the various methods:
78-4039426-01 Rev D
Setting up Input Information
143