Warnings - Cisco D9824 Installation And Configuration Manual

Chapter 6 Service and Maintenance
Alarm Message
Type
FPGA status Set
FPGA status Set
FPGA status Clear

Warnings

Warning Message
Type
ASI TS Set
Overflow
ASI TS Clear
Overflow
252
Message Cause/Remedy
FPGA ID does not Cause: Hardware
match FPGA issue.
DESIGNATION
Remedy: Clear
alarms, reset the
unit, notify
customer service if
the problem
persists.
FPGA ID does not Cause: Hardware
match HW FPGA issue.
ID
Remedy: Clear
alarms, reset the
unit, notify
customer service if
the problem
persists.
FPGA loaded
successfully and
reset
Message Cause/Remedy
ASI Output Cause: Uplink settings
Overflow may have changed since
setting up the unit.
Remedy: Increase the
output rate, drop
unreferenced content in
DPM Options, and drop
the programs that are
not needed for
downstream devices.
Contact your (uplink)
service provider to
verify the expected bit
rate settings.
ASI Output
Overflow
Cleared
Description Severity
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Description
The output rate is
higher than level set
by the user.
78-4039426-01 Rev D