Setting Up The Biss Mode - Cisco D9824 Installation And Configuration Manual

Setting up the BISS Mode

1 From the user interface of the D9824, click Input > Conditional Access > BISS.
The BISS page is displayed.
2 Select the Basic Interoperable Scrambling System (BISS) Mode for the receiver
(Mode 1 or Mode E). All channels assigned to the PE identified as BISS CA-
controlled in the PMT will be decrypted.
3 If you selected BISS Mode 1, enter a fixed 12-character BISS Mode-1 Session
Word. Once entered it cannot be viewed and it is only displayed as asterisks (*).
Contact your program provider for the session word.
4 If you selected BISS Mode E, enter the 16-character BISS Mode-E Encrypted
Session Word and the 14-character BISS Mode-E Injected ID. Once entered,
neither of these values can be viewed and it is only displayed as asterisks.
Contact your program provider for the respective session word and/or injected
ID.
5 Click Apply.
78-4039426-01 Rev D
Setting up Input Information
147