Cisco D9824 Installation And Configuration Manual page 282

Chapter 6 Service and Maintenance
Warning Message
Type
Memory Usage Set
Secondary
Memory Usage Clear
Secondary
FPGA Code Set
Version
FPGA Code Clear
Version
Ethernet PHY n Set
Ethernet PHY n Clear
FW: Resource Set
Use Host
FW: Resource Clear
Use Host
260
Message Cause/Remedy
Excessive Cause: Possible software
(stack/partition) issue.
memory usage
Remedy: Clear
warnings, reset the unit,
and notify customer
service if the problem
persists.
Normal
(stack/partition)
memory usage
FPGA newer Cause: FPGA version is
than SW, incompatible with the
Supported=AAA, software.
Running=BBB
Remedy: Select alternate
FPGA, software
versions, reset unit,
notify customer service
if problem persists.
FPGA code ver
OK
Link is down Cause: No ethernet cable
connected, faulty
cabling, multiple devices
sharing MAC address
on same IP segment, or
possible HW issue.
Remedy: Check cabling,
check MAC addresses,
clear warnings, reset the
unit, and notify
customer service if the
problem persists.
Connection OK
Memory or List Cause: Possible software
Near Full issue.
Remedy: Clear
warnings, reset the unit,
and notify customer
service if the problem
persists.
Normal Level
Description
Software exceeding
allowable memory
usage.
FPGA version is
incompatible with
currently operating
software. You may
encounter operational
difficulties
Ethernet MAC PHY
device is attempting to
reconnect to external
devices.
Software exceeding
allowable usage of
internal constructs.
78-4039426-01 Rev D