Cisco D9824 Installation And Configuration Manual page 112

Chapter 4 Front Panel Operation
Menu Item
Output Mode
90
Description
Select the DPM output mode
for the current output.
With the exception of No
Output, selecting a mode
will configure the DPM
settings to achieve the
specified behavior. In this
way, they act as DPM
presets.
Any changes then made to
the DPM settings will switch
the mode to Full DPM
Control.
It is highly recommended to
use either one of these basic
modes, or, for advanced
setup, enter the DPM
mapping before setting the
Output Mode.
Parameters
No Output - No ASI output will be
generated and the ASI port will be disabled.
Passthrough - The output will be identical
to the input. All PEs will be set to Pass and
other DPM settings will also be set.
Service Chans Only - This is similar to
Passthrough, except that only channels
applied to program entries are available on
the output.
MAP Passthrough - The output will be
identical to the input, except that channels
and PIDs will be mapped using the DPM
settings. If the input is tuned to a valid
channel, the PEs are automatically set to
Map. Otherwise, the PEs are automatically
set to Drop. When selecting MAP
Passthrough, the option to re-sync will be
provided. If you select Yes, it will set the
DPM mapping to match the current input.
If you select No, it will use the existing
DPM maps. If the PE is mapped, it uses the
last valid input. The output map (for
example, output channel PMT) does not
change automatically if the input or
channel number is changed.
MAP Svc Chans Only - This is similar to
MAP Passthrough, except that only
channels applied to program entries are
available on the output. If the input is
tuned to a valid channel, the PEs are
automatically set to Map. Otherwise, the
PEs are automatically set to Drop. When
selecting MAP Svc Chans Only, the option
to re-sync will be provided. If you select
Yes, it will set the DPM mapping to match
the current input. If you select No, it will
use the existing DPM maps. If the PE is
mapped, it uses the last valid input. The
output map (for example, output channel
PMT) does not change automatically if the
input or channel number is changed.
Full DPM Control - The output will be
generated according to the DPM settings.
This is a manual control setting.
78-4039426-01 Rev D