Viewing Version Information - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Viewing Version Information

From the user interface of the D9824, click System Settings > Versions > Versions.
The Versions page is displayed.
The Software Versions section displays the currently running loaded application
version number, the factory loaded application version number, and the Host Boot
version numbers. In the Select APP Version drop-down, you can choose a different
application version number to load. Click Select & Reboot to load the selected
application and reboot the receiver. Click Erase to remove the selected application
version. You will be prompted to continue or not. Click OK to continue the deletion.
The Firmware Versions section displays the current and safe limits for the Field
Programmable Gate Array (FPGA) version number, and the Complex
Programmable Logic Device (CPLD) version number. In the Select FPGA Version
drop-down, you can choose a different FPGA version number to load. Click Select &
Reboot to load the selected FPGA and reboot the receiver. Click Erase to remove the
selected FPGA version. You will be prompted to continue or not. Click OK to
continue the deletion.
In the Download APP section, click Browse to select the new version of FPGA or the
D9824 Advanced Multi Decryption Receiver's software application. The Choose File
dialog opens. Select the upgrade file and click Open. Click Download to download
the selected upgrade file. File formats that can be downloaded include Application
CDTs and FPGA CDTs.
Note: For application downloads, once the download is complete, the D9824 receiver
will reboot automatically. For FPGA downloads, you must click Reboot Receiver in
the Service Actions page (Support > Service Actions) to manually reboot the D9824
receiver and complete the download. This is to facilitate the typical case in which the
user intends to flash the FPGA file (no auto reboot) followed by an APP download
(auto reboot).
198 78-4039426-01 Rev D