Cisco D9824 Installation And Configuration Manual page 123

Setting
NITO
SDT
SDTO
BAT
EIT
TDT
RST
TOT
DIT
SIT
ECM
EMM
DRT
CDT
Note: The CDT is different from the other tables listed because the CDT is referred to within
the PMT, rather than outside the PMT. Select Pass to permit the output of CDTs following
the configured DPM PID map configuration and all other DPM constraints. If a DPM PID
map has not been configured for the CDT PID and the PE Act is set to Map, the CDT will still
not output. Select Drop to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs.
Setting Up Digital Program Mapping (DPM)
To set up DPM:
1 Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop or map.
2 Go to the Setup: Outputs, TS Out: DPM: Global menu and select Resync All for
the selected ASI output. This copies the input services PIDs to the remapped
output service PIDs.
3 Go to Setup: Outputs: TS Out: DPM: ASI, and select the PE containing the
channel you want to configure.
78-4039426-01 Rev D
Mode Options
Pass, Drop, PwRC
Pass, Drop, Regen, PwRC Service Description Table Pass
Pass, Drop, PwRC
Pass, Drop, PwRC
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Pass, Drop
Description
Network Information
Table - Other
Service Description Table
- Other
Bouquet Association
Table
Event Information Table
Time and Date Table
Running Status Table
Time Offset Table
Discontinuity
Information Table
Selection Information
Table
Entitlement Control
Message
Entitlement Management
Message
Disaster Recovery Table
Code Download Table
Setup Menu
Default
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
101