Cisco D9824 Installation And Configuration Manual page 213

Adding a Trap Destination
1 Click Add in the Trap Destination Configuration section.
2 Type the Trap Destination IP Address that sets the destination for SNMP trap
messages for system events (i.e. fault messages). You can enter up to 12
characters (e.g., 155.128.100.200).
3 Type the Community String for the trap destination (IP Address entered above).
4 Enter public or custom string. The default is public. You can enter a string up to
35 characters.
5 To edit/delete an existing trap destination, select the trap destination entry by
clicking on the radio button. Make the necessary changes, or click Delete to
remove the address from the Trap Destination Configuration list.
6 Click Apply.
78-4039426-01 Rev D
Configuring System Settings
191