Cisco D9824 Installation And Configuration Manual page 183

7 Select the Relay Mode that can be programmed to respond to an Alarm state,
Warning statue, or the state of one of the eight cue trigger pins. The response is
generated at the Cue Tone/Relay output on the rear panel of the receiver. The
following table shows what the possible field settings are and their relationship
to the receiver output:
Relay Mode
Alarm
Trigger
8 If the Relay Mode was set to Trigger, select the cue trigger bit/pin that will
activate the relay in the Relay Trigger Bit drop-down menu (1 to 8).
9 Click Apply.
78-4039426-01 Rev D
Condition
Unit Power Off
Alarm State
No Alarm
Active (selected in PNC) Close
Inactive
Setting up Audio and Video Information
Relay Contact
NC - C C-NO
Open Close
Open Close
Close Open
Open
Open Close
161