Cisco D9824 Installation And Configuration Manual page 203

Svc ID
All Ch
24 Select the SI Regeneration Option. This applies the PowerVu rates (consistent
with the uplink). This parameter is only used if Remapping Control is set to
None. The following table describes each PSI rate:
PSI Rate
Auto
MPEG Min
SA Std
25 The PSI Table Output Option drop-down allows the operator to specify which
PSI tables to include in the program/output stream. The following table
describes each option:
PSI Options
Pass All
Drop All
Ctl By Table
26 Select the PSI Regeneration Option drop-down, select whether to regenerate the
PSI tables. You can select Always or As Needed (only if the content has
changed).
27 If Ctl By Table was selected as the PSI Table Output Option, click Table
Options to configure the DPM table options. The DPM Table Options (MOIP)
window is displayed.
78-4039426-01 Rev D
Description
Transmits the PSI tables for the mapped program even if the
program does not exist in the input stream.
All Ch is only valid if the PAT, NIT, SDT and PMT are set to
Regenerate.
Description
Matches the generated PSI tables' output rate as the incoming rate.
Transmits the generated PSI tables on the longest intervals that are
allowed by MPEG standard.
Transmits the generated PSI tables based on PowerVu standard
intervals.
Description
Transmits the incoming PSI Tables as is; does not modify the
content and rate.
Does not transmit any PSI Tables.
The operator can click Table Options to select the output mode for
each table. The default table selections will be all pass, and only
with CDT dropped.
Configuring Transport Stream Information
181