Siemens SINUMERIK 840D sl Operating Manual page 509

This means that:
● When a DO is moved, the complete dataset is always moved, including all of the
components used in it.
● All of the DO data is symbolically displayed by the "Motor Module" component (TM, hub).
● The complete DO is always considered when adding/deleting a Motor Module.
If individual measuring systems are processed, these must be changed via the data view (see
below).
Note
Measuring system / Motor data
Note that it is not possible to assign a measuring system or motor data to a different DO by
moving a component.
Example of moving a dual-axis module from Slave 12 to Slave 13
In the following example, the marked dual-motor module is moved from NX Slave 12 X103 to
NX Slave 13 after X102. During the move, a prompt requests whether attached components,
NC or drive data should also be moved or deleted.
The colored highlighting denotes the attached data.
Figure 6-32
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Moving a dual-axis module from Slave 12 to Slave 13
Create MyConfig - Topo
6.8 Extended user-specified topology
509