Create MyConfig - Expert
4.4 Project folder
Figure 4-43
Buttons for the package execution dialogs
Information on the general buttons in the dialogs can be found at Meaning of buttons
(Page 155).
4.4.2.36
Archive data transfer (package execution)
During the display of this dialog page, the manipulated archive data of NC, PLC, and DRV are
transferred to the control.
This dialog is not listed in Expert because it is called automatically from the package without
being configured when the package data of at least one of the stated areas (NC, PLC, DRV)
has changed.
Note
All archive data present at the end of the package execution is transferred to the control. This
data has its source as specified in the configuring on the "System configuration" dialog page
and may have been changed or added by the package.
If "Do not use" was selected for "Origin of data" on the "System configuration" dialog page, no
data for this area is transferred to the control only when none was provided by the package.
218
2. Step tree dialog - commissioning engineer / operator view
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE