Verification Run - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.13 Command line call
4.13.2

Verification run

For the verification run of a package, you can also start Create MyConfig Expert in the
command line mode. The command line call is envisaged for the automated verification run
of packages.
Specify command line parameters (switches) for the verification run in command line mode.
The command line parameters are partly optional.
You can also specify a package configuration file that replaces the configurations in the
package via the command line parameters.
If a package configuration file is specified, these settings are applied to the package and this
followed by the verification run with all the specified command prompt parameters.
Call
Write the command subsequently shown as well as all associated switches and arguments in
one line to a batch file or a command line interface.
Verification run when Expert opens
Expert.exe
The switches in square brackets are optional.
Example:
Expert.exe
Notes
Note the following information for the command line call:
Note
Observe the sequence of the switches
The switches should be written to in the specified sequence.
When doing this, note the "Call" section and the "Significance of the switches" table.
Note
Path data
● Paths must be specified in straight quotation marks if spaces are included.
Example:
"C:\path with spaces\Expert_Logfile.xml"
● Paths must never end with '\'.
Note
Saving batch files
Always save batch files with ANSI/ASCII coding.
426
/verify [/config <Path config file>] <Path project file>
/verify /config ./update.upcfg D:\Projects\MyProject.upz
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE