Parameter Settings Of Cpu Module - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

4.4

Parameter Settings of CPU Module

Set the IP address and subnet mask of the CPU module, and configure the event history settings and clock settings.
Own node settings
Operating procedure
1.
Display the own node setting window.
[Navigation] window  [Parameter]  Module to be used  [Module Parameter]  [Basic Settings]  [Own Node
Settings]
2.
Set the IP address and subnet mask of the module to be used.
• If the IP address is blank, it is automatically set to 192.168.3.39.
• Set the IP address of the CPU in the same segment as the IP address of the network camera set in the
following.
Page 10 Network Camera Settings
4 PROGRAMMABLE CONTROLLER SETTINGS
4.4 Parameter Settings of CPU Module
4
42