®
ABB i-bus
EIB / KNX
4
Project design and
programming
4.1
Overview of the functions
Application program
Room Controller modular, 8f/1
4.2
General parameters
4.2.1
Parameter window:
"General"
© 2004 ABB STOTZ-KONTAKT GmbH
Project design and programming
The Room Controller has a single application program "Room Controller
modular, 8f/1" which is used to set the device function. The programming
requires the EIB Tool Software ETS2 V1.3a or higher. When using the ETS3
a ".VD3" file has to be imported.
Number of
communication objects
254
Status response of switching state
This parameter sets whether the current switching state is represented on
the bus.
The status feedback is carried out via the object "Status switch". It is sent in
the event of a change.
It is set here whether a status response (1 bit) is sent when the output is
switched on or off. A further status response object is enabled via which the
status feedback takes place.
Status response inverted
The status feedback of the switching state can be inverted with this
parameter.
The parameter is visible if the value "yes" has been selected in the
parameter "Status response of switching state". If the status response is
inverted (parameter value "yes"), the object "Status switch" has the following
values:
"0"
Lighting is switched on
"1"
Lighting is switched off
Max. number of
Max. number of
group addresses
associations
254
255
...
19