Samsung DCS Technical Manual page 81

SAMSUNG DCS
TECHNICAL MANUAL
3d. Enter desired selection from table "F"
(eg., 04)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
3e. Enter desired selection from table "G"
(eg., 05)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
3f. Enter desired selection from table "H"
(eg., 06)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
3g. Enter desired selection from table "I"
(eg., 07)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
3h. Enter desired selection from table "J"
(eg., 08)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
3i. Enter desired selection from table "K"
(eg., 09)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
3j. Enter desired selection from table "L"
(eg., 10)
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor to
step 4
4. Enter desired selection from table
"C" (eg., 1)
Press UP or DOWN key to make selection
and press LEFT soft key to move cursor
back to step3, and continue entries
Proceed to step 5
5. Press TRSF to store and exit
Page 81 of 287 Updated I&M
OR
OR
OR
OR
OR
OR
OR
OR
OR
PROGRAMMING
[257] SIM PARA.
DTR CHECK : ON
[257] SIM PARA.
ECHO : ON
[257] SIM PARA.
PROTOCOL : V110
[257] SIM PARA.
SPEED : 9600
[257] SIM PARA.
CHAR LENG : 8 BITS
[257] SIM PARA.
PARITY : NONE
[257] SIM PARA.
STOP BIT : 1
[257] SIM PARA.
CALL MODE : AWITH
May 2002
SECTION