Samsung DCS Technical Manual page 228

SAMSUNG DCS
TECHNICAL MANUAL
MMC 725:
DESCRIPTION:
Allows the System Administrator or technician to select the information printed on the SMDR report. The
following options may be selected to print on SMDR:
0. PAGE HEADER
1. LINE PER PAGE
2. INCOMING CALL
3. OUTGOING CALL
4. AUTHORISE CODE
5. LESS START TIME
DCS 70 NOTE:
6. IN/OUT GROUP
7. DND CALL
8. WAKE-UP CALL
9. DIRECTORY NAME
10. CLIP
11. ABANDON CALL
DCS
12 DID NUM/NAME
DCS70
12. NO. OF DIAL MASK
The DIRECTORY NAME that appears on the SMDR header is programmed as follows:
Names are written using the keypad. Each press of a key will select a character. Pressing the next key will
move the cursor to the next position. For example, if the directory name is "SAM SMITH," press the number
"7" three times to get the letter "S." Now press the number "2" once to get the letter "A." Continue selecting
characters from the table below to complete your message. Pressing the bottom left programmable key will
change the letter from upper case to lower case.
Page 228 of 287 Updated I&M
This option determines whether a page header will print at the top of
each page. This would normally be turned off if SMDR is being sent to a
call accounting machine.
This option selects the length of each page to determine when to print
the SMDR header. The number of lines may be in the range 01-99.
This option determines whether incoming calls will print on SMDR.
This option determines whether outgoing calls will print on SMDR.
This option determines whether authorisation codes will print on SMDR.
This option determines whether valid calls will include the minimum call
time in total call duration.
LESS START TIME IS REFERRED TO AS SMDR START TIME
This option allows a message, IN GROUP or OUT GROUP, to be
printed in the Digits Dialled column each time a station enters or leaves
a group.
This option allows a message, IN DND or OUT DND, to be printed in
the Digits Dialled column each time a station enters or leaves DND.
This option determines whether stations receiving an alarm reminder
call will print on SMDR.
This option allows the system administrator to enter a 16 character
name which will appear on the SMDR header.
This option can be selected to print CLIP data received from the CO on
incoming ISDN calls. This option requires the use of a 132 column
printer or an 80 column printer set for condensed print.
If this option is set to YES unanswered calls will print on SMDR.
If this option is set to YES the DID number and name will print on
SMDR in the Outgoing call number field.
Determines if number of masked dial digits print on SMDR
PROGRAMMING
SECTION
SMDR Options
May 2002