Samsung DCS Technical Manual page 119

SAMSUNG DCS
TECHNICAL MANUAL
MMC 420:
DESCRIPTION:
This MMC allows the DCS system to be programmed for DDI/NORMAL Access, dial sending mode to
OVERLAP or ENBLOCK and whether the system is able to select any channel for an outgoing call or the
specific channel selected. The Channel Any mode should be set to No if you wish to allocate specific trunks
to tenants or customers wish to have specific line key appearances programmed on their keysets.
If the dial sending mode is changed on any port of the DCS, all other ports will be set to same dial sending
mode. If the PRI line is not equipped for DDI service by the Network Provider, the NORMAL mode should be
used. (eg., sub-address or normal trunk incoming service) If the PRI MODE is set to DDI, DDI (Direct Dial
Inward) incoming Trunk calls can be directed to a specific station or station group according to DID NUMBER
TABLE in MMC 714.
NOTE: DLRECV is not required in Version 4+ software as the system will wait for additional digits until
sending complete is received in the SETUP message.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
ACTION
1. Press TRSF 420
Display shows
2. Dial PRI trunk number (eg., 704) or press
UP or DOWN key to select the port.
Use the RIGHT soft key to position the
cursor under DSEND
3. Press UP or DOWN key to make selection
(DLSEND, PRI MODE or
CHANNEL ANY). Select DLSEND
and press RIGHT soft key to move the
cursor under OVERLAP. Use UP or DOWN
key to select ENBLOCK/OVERLAP. Press
RIGHT soft key to make the selection.
4. Use UP or DOWN key to get to PRI MODE.
Press RIGHT soft key to move the cursor
under DDI/NORMAL. Use UP or DOWN key
to make the selection
5. Press TRSF to store and exit
Press SPK to store and advance to next
MMC
DEFAULT DATA:
RELATED ITEMS:
Page 119 of 287 Updated I&M
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
OR
DLSEND :
PRI MODE :
CHANNEL ANY:
MMC 418
DISPLAY
[701]
DLSEND
[704]
DLSEND
[704]
DLSEND
[704]
PRI MODE
OVERLAP
NORMAL
YES
CARD RESTART
PROGRAMMING
SECTION
PRI Option
PRI OPTION
:OVERLAP
PRI OPTION
:OVERLAP
PRI OPTION
:OVERLAP
PRI OPTION
: DDI
May 2002