Samsung DCS Technical Manual page 224

SAMSUNG DCS
TECHNICAL MANUAL
MMC 724:
The following details the Ports default data for DCS 70 and DCS 24. The FEATURES listed are
applicable to DCS 24, DCS 70 and DCS 200 with Version 6 software installed. Some features do not
apply to Ver 5.XX DCS 70 or DCS 24 – these are noted accordingly.
DESCRIPTION:
Provides the access codes and dialling plan needed for operation of features and programs. The system
comes with a wide range of acceptable numbering plans set as default and the option to customise the
dialling plan. An error message is also provided in case an access/feature code is duplicated.
The following options may be selected:
0 STN DIAL NUMBER
1 TRK DIAL NUMBER
2 STNG DIAL NUMBER
3 TRKG DIAL NUMBER
4 FEAT DIAL NUMBER
5 MISC DIAL NUMBER
6 S0 STN DIAL NO.
7 DECT STN DIAL NO
Feature codes are entered via the dial keypad, by pressing numbers as shown in the table below. For
example, for OHVA, the number 6 would be pressed three times. If Block Code is required, press 2 for
the first letter B and then use the UP or DOWN key to make the selection from BARGE to BLOCK.
Important: Remember that this program is system wide.
COUNT
DIAL 2
DIAL 3
DIAL 4
DIAL 5
DIAL 6
DIAL 7
DIAL 8
DIAL 9
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
Page 224 of 287 Updated I&M
Determines the station port dialling numbers
Determines the trunk port dialling numbers.
Determines the station group dialling numbers.
Determines the trunk group dialling numbers.
Determines the feature codes.
Determines the miscellaneous port dialling numbers.
Determines the S0 station dialling number.
Determines the DECT station dialling number. (Not DCS 24)
DIAL KEYPAD
1
AAPLAY BARGE
DICT DICT
GPIK HDSET
LCR LCR
MMPA NEW
PAGE REJECT
UA
WCOS WCOS
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
Dial Numbering Plan
2 3
CAMP
FAUTO
IOG
LCR
OHVA
SETMG
UA VDIAL
WCOS
PROGRAMMING
SECTION
May 2002