Samsung DCS Technical Manual page 136

SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL SECTION
AA TRANS TIME: After this time, compare input digit with AA translation table (MMC 732) and transfer to
destination.
ALERT TONE TIMER: This timer sets the duration of the attention tone preceding a call to a keyset in the
Voice Announce or Auto Answer mode. This tone will also precede a forced Auto Answer call.
ALM REM INTERVAL: This timer controls the time between ring attempts at a station when alarm reminder
is set.
ALM REM RING OFF: This timer controls the length of the ring cycle duration when alarm reminder is set at
a station.
ATT RECALL TIME: This is the length of time a transfer recall will ring at a station before recalling the
operator.
AUTO REDIAL INT: This timer controls the time between attempts after RETRY dialling is set on a station.
AUTO REDIAL RLS: This timer controls the duration of a Ring No Answer condition on a retry number
dialled before the auto redial is automatically cancelled.
DCS70 – BARGE IN TONE: This timer controls the intervals between the tones sent to the keyset that is
being barged in on.
CALLBACK NO ANS: This timer controls the time before the callback is automatically cancelled when a
callback detects Ring No Answer.
CAMP ON RECALL: This timer controls the duration of time a camped-on call will stay at a destination
before recalling to the transferring station.
CLIP DISPLAY TIME: The amount of time that the Calling Line ID information remains on the keyset's
display.
CLIP MSG RECEIVE: The amount of time that the system will allow a valid message from the CO
CLEAR CO TIME: The length of time a DTS key remains busy after cleardown.
CO CONFIRM TIME: After this time, the outgoing call is disconnected or you can hear the confirm tone.
CO-CO DISCONNECT: This timer monitors the duration of a unsupervised conference; when it expires, both
trunks are disconnected.
CONFIRM TONE TIME: The time tone confirmation is heard when a feature is activated or deactivated.
CRD TONE INT TIME (Call Recording Tone Interval Time): This timer controls the timing of intervals
between the tones which indicates the call is recorded by Cadence.
DATA EXIT TIME : Not used now.
DATA OTASK TIME : Not used now.
DIAL PASS TIME: This timer is the wait time for preventing the mis-dialling of an outgoing call. After the last
digit has been dialled, the voice path is connected.
DISA DISCONNECT: This timer controls the maximum duration of a DISA call.
DISA LOCK OUT TIMER: This timer controls the duration of time a DISA call is not allowed to be made after
the DISA error counter has expired (MMC 500).
Page 136 of 287 Updated I&M May 2002