Samsung DCS Technical Manual page 231

SAMSUNG DCS
TECHNICAL MANUAL
MMC 726:
DESCRIPTION:
Provides a flexible means of setting in band signalling for voice mail or auto attendant parameters. There are
eight main options for programming and several sub-options to customise the application. Main options are
listed in bold type with the sub-options listed in normal type. Simple YES/NO, numeric and alpha characters
are the requirements needed for the setting of VM/AA.
The following options may be selected for VMAA operation:
In band signalling OPTIONS LIST 0-7
0. EXT FOR DN1
1. TRK FOR DN1
2. EXT FOR DN2
3. TRK FOR DN2
4. SEPARATOR
5. DISCONNECT
SIGNAL
6. CALL TYPE ID
0. DIRECT CALL
1. ALL FWD CALL
2. BSY FWD CALL
3. NOA FWD CALL
4. RECALL
5. DIR TRK CALL
6. OVERFLOW
7. DID CALL
8. MESSAGE CALL
7. CALL PROGRESS
Page 231 of 287 Updated I&M
DTMF information for the station that called the VM/AA port station
that is forwarded to VM/AA port.
DTMF information for the trunk that called the VM/AA port.
DTMF information for the station that originated the call to a station
that is forwarded to a VM/AA port.
DTMF information for the trunk that called a station forwarded to a
VM/AA port.
In cases where DN2 is used, this specific digit is sent between the
DN1 and the DN2 information. Both DN1, DN2 must be set to YES for
SEPARATOR to be sent.
This signal is sent when the calling station or CO line hangs up.
Under this VM/AA option is several customising applications.
A call originating directly from another station in the system.
This indicates that a call was forwarded to the VM/AA port from a
station with CALL FORWARD ALL set.
This indicates that a call was forwarded to the VM/AA port from a
station with CALL FORWARD BUSY set.
This indicates that a call was forwarded to the VM/AA port from a
station with CALL FORWARD NO ANSWER set.
A call is recalling the VM/AA port after being transferred and not
answered.
A CO call has gone directly to VM/AA (eg., trunk 717 DIL to VM/AA).
A call has OVERFLOWED to the VM/AA port from a station group.
A DID call has called the VM/AA port.
A message button or message reply feature code has been used to
call the VM/AA port.
DTMF digits can be sent in place of normal system TONES. Digits can
be assigned to the following tones:
PROGRAMMING
SECTION
VM/AA Options
May 2002