Samsung DCS Technical Manual page 52

SAMSUNG DCS
TECHNICAL MANUAL
MMC 210:
DESCRIPTION:
Allows the System Administrator to set in the system features on a per-tenant basis listed below.
0. DISA PSWD
1. LCR ENABLE
2. PERI UCD SET
3. SMDI VMS SET
4 DISA MOH
5 SMDR MASK
6 XFER MOH
7 DSP SSPDNAME
DDIfback→ → → → 406
8
9 OPER RECALL
10 DID BSY ROUT
11 DID NOT ROUT
12 ALL PICK UP
13 ARD TONE CHK
14 CONF TONE
15 VPN ENABLE
16 ISDNTRK BUSY
17 CID CODE INS
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
ACTION
1. Press TRSF 210
Display shows
2. Press RIGHT soft key to move cursor
Page 52 of 280 DCS & DX I&M
Customer On/Off per Tenant
It toggles ON and OFF to decide when accessing the DISA facility a DISA
PASSCODE is required or not.
This will enable LCR feature to be worked in the system.
Periodic UCD Information provider. Enables UCD Statistics data on a per UCD
group basis to print out on the IO port which has been set as SMDR or UCD
REPT in real time (every 10 seconds). This allows the information to be
manipulated by the external third-party provided Software package.
Allows SMDI integration through RS-232 port for the external PC-based VM
system. NOT USED in Version 5.x software or above
Provides the option of presenting DISA callers with information supplied by the
MOH source rather than DISA dial tone
When set to ON the last 2 digits of a telephone number is masked out on SMDR
printout.
When set to ON callers receive MOH instead of ring tone on all transferred calls.
When set to ON LCD keysets will display the name of the SPEED DIAL bin in lieu
of the number, where a name has been programmed. This does not apply when
the Directory feature is used.
Allows DDI calls to busy destinations (with Call wait set to NO) to be routed to an
assigned destination using MMC 406.
When set to OFF recalls will remain at the station that placed the call on hold or
transferred the call rather than reverting to the Operator.
When selected station is busy, DID call can be routed to an assigned destination,
in MMC 406, before the call is dropped.
When not connected or invalid station number is selected, DID call can be routed
to an as assigned destination, in MMC 406, before the call is dropped out
Independent Pickup group, can pick up the all calls
When system detects CO BUSY TONE from Central Office, return to autoredial
state.
If set to ON a Conference Tone is audible every CONFER TONE INT TM in MMC
501
Enables the system to inter-work with the OPTUS VPN
If ON, when the destination group extensions for an incoming ISDN trunk call are
all busy, the call is dropped out and outside caller will hear busy tone. This
feature is only applied for ISDN Trunk. When the destination is a Station Group is
set for Unconditional Mode, this feature will not be operate.
Allows the digit "1" to be automatically inserted for a toll call – Not used in
Australia
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
PROGRAMMING
DISPLAY
TEN. ON AND OFF
LCR ENABLE :OFF
TEN. ON AND OFF
August 2001
SECTION