Bpx Switch Routing Hubs - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

BPX Switch Operation

BPX Switch Routing Hubs

T1/E1 Frame Relay connections originating at IGX switch interface shelves and T1/E1 Frame Relay,
T1/E1 ATM, CES, and FUNI connections originating at MGX 8220 interface shelves are routed across
the routing network via their associated BPX switch routing hubs.
These requirements apply to BPX switch routing hubs and their associated interface shelves:
•
•
•
•
•
•
•
•
•
•
Cisco BPX 8600 Series Installation and Configuration
1-14
Only one feeder trunk is supported between a routing hub and interface shelf.
No direct trunking between interface shelves is supported.
No routing trunk is supported between the routing network and interface shelves.
The feeder trunks between BPX switch hubs and IGX switch interface shelves are either T3 or E3.
The feeder trunks between BPX switch hubs and MGX 8220 interface shelves are T3, E3, or
OC-3-c/STM-1.
Frame Relay connection management to an IGX switch interface shelf is provided by Cisco WAN
Manager.
Frame Relay and ATM connection management to an MGX 8220 interface shelf is provided by
Cisco WAN Manager.
Telnet is supported to an interface shelf; the vt command is not.
Frame Relay connections originating at IGX switch interfaces shelves connected to IGX switch
routing hubs may also be routed across BPX switch intermediate nodes.
Remote printing by the interface shelf via a print command from the routing network is not
supported.
Chapter 1 The BPX Switch: Functional Overview
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001