Cisco BPX-BXM-155-8DX Installation And Configuration Manual page 301

Chapter 21 Configuring ATM Connections
pubsbpx1
Local
Channel
2.2.1.4
2.2.1.5
2.2.1.6
2.3.5.7
2.3.5.8
2.3.5.9
This Command: addcon 2.2.11.11 pubsbpx1 2.3.12.12
Enter (nrt/rt-VBR,CBR,UBR,ABRSTD,ABRFST,ATFR,ATFST,ATFT,ATFTFST,ATFX,ATFXFST)
or class number:
Instead of entering a class of service, you can instead enter a class number to select a pre-configured
template, for example, class 4 for NTR-VBR, and class 3 for RT-VBR. You can modify the class of
service templates as required by using the cnfcls/cnfatmcls command and displaying them by using the
dspcls/dspatmcls command.
Note For a new node running 9.2.20 or later, the rt-VBR connection class number is 3. An
upgraded node will retain existing connection classes. Therefore, it won't have the
rt-VBR connection class 3. However, the user can configure the connection classes to
whatever service and parameters they want using the cnfcls/cnfatmcls command.
An example of a cnfcls/cnfatmcls command and response is shown in the following example:
pubsbpx1
Class:
PCR(0+1)
1000/1000
1000/1000
This Command: cnfcls atm 2
Enter class type (rt-VBR, nrt-VBR, CBR, UBR, ABRSTD, ABRFST, ATFR, ATFST, ATFT,
ATFTFST, ATFX, ATFXFST):
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
TN silves BPX 8620
Remote
NodeName
pubsbpx1
pubsbpx1
pubsbpx1
pubsbpx1
pubsbpx1
pubsbpx1
TN silves:1
ATM Connection Classes
2
% Util
100/100
MBS Policing
3
Description: "Default nrt-VBR 1000 "
9.2.2G July 21 1999 21:32 PDT
Remote
Channel State
2.3.5.7 Ok
2.3.5.8 Ok
2.3.5.9 Ok
2.2.1.4 Ok
2.2.1.5 Ok
2.2.1.6 Ok
BPX 8620 9.2.2G
CDVT(0+1) AAL5 FBTC
10000/10000 n
Cisco BPX 8600 Series Installation and Configuration
ATM Connection Requirements
Route
Type Avoid COS O
nrt-vbr
rt-vbr
rt-vbr
nrt-vbr
rt-vbr
rt-vbr
July 16 1999 10:42 PDT
Type: nrt-VBR
SCR
1000/1000
21-9