Configuring The Lan Port; Configuring The Cisco Wan Manager Workstation - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Configuring the LAN Port

Step 3 Enter the name or IP address of the gateway node in config.sv, using physical LAN name, such as,
"nw1bpx1p".
Note: normally a BPX switch is used for the gateway node because of its greater processing power.
0|Network1|nw1bpx1p|9600|0|7|6|0|30|1024|9.1|
or
0|Network1|204.179.61.104|9600|0|7|6|0|30|1024|9.1|
Enter IP Relay subnet mask in /etc/rc2.d/S72inetsvc file:
Step 4
vi /etc/rc2.d/S72inetsvc
/usr/sbin/route add "224.0.0.0 ...................{this is already there
# route add for Cisco WAN Manager
route add net 204.179.55.0 204.179.61.104 1
Note The routeAdd command sets up the route for all nodes in the 204.179.55.0 IP relay
subnetwork. In this example, the name "nw1bpx1p" is the name in the /etc/hosts table
associated with the physical LAN port IP of 204.179.61.104 on the gateway node, such as,
"nw1bpx1". In steps 2 and 3, either the name "nw1bpx1p" or the IP of "204.179.61.104"
can be entered.
Configuring the LAN Port
Configure the LAN parameters of the nodes before connecting them to a LAN.
Note
Refer to the Cisco WAN Manager Operations for instructions on configuring the Cisco WAN Manager
workstation. Refer to the Cisco WAN Switching Command Reference for command definitions.
Contact your System Administrator to obtain IP addresses for your workstation and for the BPX/IGX
Step 1
switches you are going to configure. Also, access to the NIS directories should be disabled so that the
workstation will consult the /etc/hosts table for IP LAN relay addresses.
Normally, the System Administrator will provide the IP addresses for the workstation and node.
The addresses shown are just examples. Use the addresses obtained from your System Administrator.
(This example is for a workstation named "hedgehog" at address 192.187.207.200. It also assumes that
the BPX or IGX switch LAN port for node sanfran has been assigned an IP address of 192.187.210.30
and a hostname of sanfran. Your own host name and addresses will be different.)
192.187.207.200
192.187.210.30
Note
Note
Cisco BPX 8600 Series Installation and Configuration
20-6
hedgehog
sanfran
If an NIS is being used (such as, corporate network), you will need to contact the
system administrator.
5120 is used for the LAN ports on all BPX switch ports.
Chapter 20 Configuring Network Management
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001