Command Line Interface Examples - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Command Line Interface Examples

•
•
•
Command Line Interface Examples
This section contains command examples, including configuring BXM lines and trunks and adding
connections terminating on BXM cards.
An example of the uptrk command for trunk 1 on a BXM in slot 4 of a BPX switch:
Cisco BPX 8600 Series Installation and Configuration
24-4
– dsptrkstathist
Display statistics data for a trunk
Channel Statistics
– cnfchstats
Configure channel statistics collection
dspchstatcnf
–
Display statistics configuration for a channel
dspchstathist
–
Display statistics data for a channel
– dspchstats
Display channel statistics (multisession permitted)
Line Statistics
– cnfslotalm
Configure slot alarm threshold
– dspslotalms
Display slot alarms
– clrslotalm
Clear slot alarm
– dspsloterrs
Display slot errors
Statistical Trunk/Line Alarms
– cnflnalm
Configure line alarm threshold
– dsplnerrs
Display line errors
– dsplnalmcnf
Display line alarm configuration
– clrlnalm
Clear line alarm
Chapter 24 Configuring BXM Virtual Circuits
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001