Connecting Cables To Bxm T3/E3 Cards; Figure 12-5 Installing Bxm T3/E3 Cable Bracket - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 12 Installing the T3/E3 Cable Management Tray

Figure 12-5 Installing BXM T3/E3 Cable Bracket

BXM

Connecting Cables to BXM T3/E3 Cards

To route the cables as shown in Figure 12-6 and Figure 12-7:
Step 1 Connect the cables to the card by pushing on the SMB connector locking sleeves as you push the cable
connectors on to the card connectors.
Step 2 Dress the cables upward to provide a service loop.
Step 3 Bundle the cables by using cable ties.
Step 4 Wrap the cable strap around the cables and secure them to the cable management bracket.
Note
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
To disconnect cables from a card, pull on the cable connector locking sleeve as
you pull the cable connector away from the card connector.
Connecting Cables to BXM T3/E3 Cards
Card
bracket
Captive
screw
Cable
strap
Cisco BPX 8600 Series Installation and Configuration
12-5