Table 15-4 Switch 1 Settings-Okidata 184 Printer; Table 15-5 Switch 2 Settings-Okidata 184 Printer; Procedure To Attach A Local Printer - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Connecting a Network Printer to the BPX Switch
The High Speed Serial Interface DIP Switch consists of two DIP switches, SW1 and SW2, located on
a serial-board attached to the printer's main board.
Set switches 1 and 2 as indicated in Table 15-4 and Table 15-5.
Table 15-4 Switch 1 Settings—Okidata 184 Printer
Switch 1
1
2
3
4
5
6
7
8
Table 15-5 Switch 2 Settings—Okidata 184 Printer
Switch 2
1
2
3
4
5
6
7
8
For the pin assignments for the AUXILIARY port on the BPX switch and the recommended
RS-232/V.24 cable pinout and printer DIP switch settings, see Chapter 32, BPX Switch Cabling
Summary.

Procedure to Attach a Local Printer

To attach the printer to the BPX switch:
Check the printer RS-232/V.24 cabling pinout, and if required adjust the DIP switches to the settings
Step 1
indicated for the type of printer to be connected to the BPX switch.
For nodes with single BCC: Connect the RS-232/V.24 printer cable to the AUXILIARY port on the
Step 2
LM-BCC back card (see Figure 15-3). Go to Step 4.
Cisco BPX 8600 Series Installation and Configuration
15-8
Chapter 15
Setting Description
On Odd parity.
On No parity.
On 8 data bits.
On Ready/busy protocol.
On Test select circuit.
On Print mode.
On Busy line selection.
On DTR pin 2 enabled.
Setting Description
Off Transmission
On Speed = 9600 baud.
On Speed = 9600 baud.
On DSR active.
On Buffer = 32 bytes.
On Timing = 200 ms.
On Space after power on.
Don't care Not used.
Connecting Temporary Terminal and Attaching Peripherals
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001