Installing Router Assembly In A Cisco Cabinet; Figure 8-6 Assembly Of Router In Router Enclosure - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 8 Installation with Cisco Cabinets including 7000 Series Routers
Figure 8-6
Cable
management
bracket

Installing Router Assembly in a Cisco Cabinet

Install the router enclosure assembly in BPX 8650 cabinet (see Figure 8-7):
Step 1 Slide the router enclosure assembly into the cabinet on top of the BPX shelf.
Attach the two support brackets from the hardware kit, one to each vertical rail at the back of the cabinet
Step 2
as shown using two screws to secure each. The support brackets have a horizontal flange that supports
the router enclosure assembly.
Secure the front of the router assembly to the cabinet rails with two screws on each side.
Step 3
Step 4 Secure the router enclosure assembly to the cabinet with mounting screws.
Connect the power cord to router connector receptacle at the front of the cabinet, and close the router
Step 5
enclosure assembly door.
Use the tie wraps provided in the hardware kit to secure power cord to a Cable Management Bracket.
Step 6
If this is a DC-powered shelf, proceed to Chapter 10, Installing the DC Shelf.
Step 7
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Assembly of Router in Router Enclosure
Slots for tie wraps
used for cable
management
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
Hook goes into
square cutout
Cisco BPX 8600 Series Installation and Configuration
Door-opening
tabs
Door-opening
tabs
L a b e l
Optional door-opening
screwdriver access cutouts
GIN E-1 50
SIN G EN
K PR OC ES
NE TW OR
le r
C o n tr o
S w it c h
8-7