Installing Back Cards; Figure 13-4 Laser Information Label - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Installing the Cards

Installing Back Cards

Caution Ground yourself before handling BPX switch cards by placing a wrist strap on your wrist
and clipping the strap lead to the cabinet, or use the wrist strap that is connected to the
cabinet.
The optical ports contain an information label as shown in Figure 13-4.

Figure 13-4 Laser Information Label

CLASS 1 LASER PRODUCT
LASER PRODUKTDER KLASSE 1
PRODUIT LASER DE CLASS 1
Warning Invisible radiation may be emitted from the optical ports of the single-mode or
multi-mode products when no fiber cable is connected. Avoid exposure and do not look
into open apertures. (For translated versions of this warning, refer to the Regulatory
Compliance and Safety Information that accompanied your equipment).
Class 1 laser product. (For translated versions of this warning, refer to the Regulatory
Warning
Compliance and Safety Information that accompanied your equipment).
Warning Laser radiation when open. (For translated versions of this warning, refer to the
Regulatory Compliance and Safety Information that accompanied your equipment).
To install back cards:
Locate the card slot for the card to remove or install.
Step 1
For existing installations, remove any cables that may be attached and label them so they may be
Step 2
replaced in the same location.
Loosen the captive mounting screws on both top and bottom of the line module faceplate by using a
Step 3
slotted blade screwdriver (see Figure 13-5).
Step 4 Lift the extractor handles at the top and bottom, and slide out the line module.
To re-insert the line module, locate the corner edges of the card into the appropriate guide slots at the
Step 5
top and bottom of the card cage. Gently slide the card in all the way to the rear of the slot and push to
seat the card in the connector.
Note
Screw in the captive screws.
Step 6
Cisco BPX 8600 Series Installation and Configuration
13-6
47-4182-01
The card should slide in easily. Investigate any binding.
Do not use excessive force.
Chapter 13 Installing the BPX Switch Cards
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001